Switch settings for ALTEK Digitizer Controllers - using Win95 and WinNT
alswitch.txt  (18 June 1998)

0 = OFF, 1 = ON

Controller:  AC31
					
        S1              S2      S3      S4
1       0               0       1       1
2       0               0       0       1
3       0               0       1       0
4       1               0       0       0
5       1               1       0       0
6       ?               0       1       0
7       1               0       0       0
8       0 - DATATAB     0       0       0
        1 - Liteline

Controller:  AC41

On the set-up menu choose the following: Format #8 ,9600 Baud,
Parity = None, Databits = 8, Stopbits = 1, Stream Type = Run,
Rate = 50, Run Type = 2, Increment = 10, Inc. Type = Radial,
English = Mils, Table Type = ?, Control Mode = Altek, Buffer = 1,
DTE & DCE Ports = ON/Data/Message, PRN = X, Beeper = ?, CR = X,
LF = X, CTS = OFF. After setting to these parameters choose
"SAVE" Storage 1 (make sure you hear the unit beep to be sure
that it saved)

Controller:  AC30

        S1      S2
1       0       0
2       0       0
3       1       0
4       1       0
5       1       1
6       1       0
7       0       0
8       1       0


Controller:  AC40

    ON <----                        ON <-----
      8 *                                *8
      7 *                                *7
     *6                                   6*
     *5                                   5*
      4 *                                 4*
      3 *                                 3*
     *2*                                  2*
     *1                                  *1
----------------               -------------------
     *8                                  *8
     *7                                   7*
     *6                                  *6
      5*                                  5*
      4*                                  4*
      3*                                  3*
    * 2                                   2*
      1*                                 *1